Rotating Probes (Reflection) are available in two options, Rigid Stainless Steel and Delrin Flexible. Rigid Stainless Steel Probes offer high wear resistance, whereas flexible probes are used when hole tolerances are poor and access is not directly in line with the hole.
| ♦ ||Probe diameters from 1.6 to 50mm available in 0.01mm steps. |
| ♦ ||Fischer connector to Hocking, GE, Rohmann and Forester drive units |
| ♦ ||Frequency range from 200kHz to 2MHz |
| ♦ ||Comes in rigid stainless steel and Delrin flexible options. |
| ♦ ||Available in a wide range of diameters |
| ♦ ||Counter-sink and counter-bore options are available upon request |
Differential Rotating Probes - for internal diameter inspection of bore holes, counter-sinks and counter-bores.
Rigid Stainless Steel Probe Coding
Rigid Stainless Steel Probe Coding Continued
Delrin Flexible Probe Coding
Note: When ordering Rotating Probes 0.1mm is automatically taken off the probe diameter during manufacture, this should be fine for typical hole conditions and manufacturing tolerances. Where tolerances are poor, allow for greater clearance.