DeFelsko Standards
Certified Thickness Standards
Certified thickness standards are used to verify the accuracy and operation of coating thickness gages and are an important component in fulfilling both ISO and in-house quality control requirements. All standards described below are supplied with a certificate of calibration showing traceability to NIST/NPL.
There are 5 types of coating thickness standards:
Certified Coated Metal Plates
 |
Certified Coated Metal Plates are the best solution for verifying the calibration, accuracy and operation of most magnetic, eddy current or ultrasonic coating thickness gages including magnetic pull-off gages as well as many competitive models. At ±0.43µm (±0.017 mil) Certified Coated Metal Plates are the most accurate solution. |
Set of Coated Ferrous Plates
Part# for Epoxy on Steel: CT-DF-CALS
Product Codes: STDS, STDS2, STDS3
Set of Coated Non-Ferrous Plates
Part# for Epoxy on Aluminum: CT-DF-CALA
Product Codes: STDA1, STDA2, STDA3
For additional information and product code details please click on the link - Certified Coated Metal Plates
Certified Polystyrene Blocks
 |
Certified Polystyrene Blocks are for use with gages that measure over 1500 µm (60 mils).
They have an accuracy of:
±(2.5 µm + 0.05% of thickness)
±(0.1 mil + 0.05% of thickness)
|
Polystyrene Blocks
Part# of Polystyrene: CT-DF-CALP
Product Codes: STDP1, STDP2, STDP3, STDP4, STDP5, STDP6, STDP7, STDP8
For additional information and product code details please click on the link - Ceritified Polystyrene Blocks
Certified Plastic Shims
 |
Certified Plastic Shims (foils) provide an economical alternative to coated metal plates. They have a reduced accuracy of ±2 µm (0.08 mil). A coating thickness gage measures shim thickness when the shim is placed over a smooth metal surface (zero plate). Alternatively, they can be placed over an uncoated metal substrate. They are not suitable for use with magnetic pull-off gages. |
Certified Plastic Shim Set
Part# of Certified Plastic Shim Set: CT-DF-CALCSS
Product Code: STDCSS
For additional information and product code details please click on the link - Certified Plastic Shims
Non-Certified Plastic Shims
 |
Non-Certified Plastic Shims (foils) provide a quick operational check of the instrument and they allow the user to perform practice measurements when placed over metal. They are not suitable for use with magnetic pull-off gages. |
Non-Certified Shim Set
Product Code: STDSHIMS
For additional information and product code details please click on the link - Non-Certified Plastic Shims
Zero Plates
 |
Zero plates are uncoated steel (1018 steel) or aluminum (6061-T6) disks. A zero plate is included with most coated metel sets. The first gage measurement is on a zero plate to verify the gage measures zero correctly. Electronic gages can usually be adjusted to 0 if necessary. A zero plate is also a convenient base onto which a plastic shim or polystyrene block can be placed for measurement. Plate diameter: 38 mm (1.5"). |
Zero Plates
Product Codes:
Small - Steel: STDZSTL
Small - Aluminum: STDZSALM
Medium - Steel: STDZSTLM
Medium - Aluminum:STDZSALMM
Large - Steel: STSZSTLL
For additional information and product code details please click on the link - Zero Plate
Note: Specify product code in comments box during checkout.
